Anti-static wrist strap SL-035 tester anti static hand ring electric tester static tester

OneThis is a special wrist strap tester,Foot band tester,Mainly used for testing the quality of the wrist band and foot band.

2Stable performance,Ambient operating temperature,Can be suitable for a variety of working environment,The selected circuit layout is reasonable,Circuit stability,Outside interference is small,Convenient adjustment,On this product.

3The external tester port is connected with the wrist strap pin board,The wrist snap ring and the metal contact closely,Press the button.When the external loop is up to the10MQAbove or below800KQtime,The tester will automatically send out sound and light alarm monitoring circuit,Remind the user to pay attention to(Wrist band damage).

4This tester has a sensitivity,Independent adjustment port,Has been adjusted before the factory,Do not change the scope of its application,If the problem does not bear the loss caused by its own adjustment,special requirements,Please contact the supplier.

FiveExternal DC tester9VBattery. The allowable range of this tester800KLess than or equal toRLess than or equal to10MK5%Special specifications will be notified separately.

6This tester is widely used,Can be connected to all theESDStandard wired wrist band,Its interface is banana jack.

     Operating voltage: 9V

  Low resistance warning< ohms 800K

  High resistance warning> ohms 10M

  Operating temperature0 - 40centigrade

Operation instructions:

OneAfter the test instrument in the battery box9VBattery.

TwoA banana clip is inserted to connect the tester to the ground wire clamp.

ThreeTo get started, Dai Wan, to be close to the wrist.

FourAnd the ground receiving arm belt.

FivePress the test button on the front of the instrument.

Visible light emitting diode display lampLight and hear the sound signal

(OneIf green"PASS"The light is on, then the system is safe.

(TwoIf red"LO"Light, need to check with hand and ground resistance, when less thanEight hundredThousands of Europe, this will have a impact on human safety

(ThreeIf red"HI"The lamp, please check whether the handle on the wrist wear tight, and then check the arm belt and ground wire is broken.

Working status of wrist band of real time testing instrument

Two.Use state

(1)Normal working condition:red`Green alarm indicator light is not bright,Alarm does not ring.

(2)Detecting instrument and human body contact:Red alarm light,Alarm sound.

(3)Poor contact with ground wire:Green alarm light,Alarm sound.

(4)When the detector is in contact with the human body,At the same time and the ground is also poor contact,red`Green warning lights alarm.