6CH RS485 Relay Module Switch Decoder With Remote Control Compatible With Pelco-D

Circuit board default Pelco-D agreement of up, down, left, right, change times +, times - 1-6 road relay control points.Press the button corresponding control relay contract which the state of the indicator light absorption, loosen the corresponding control relay disconnect at the same time, this light is put out.If you need to set up other command control or other work mode, please refer to the "relay module serial debugging assistant" instruction set.

Debug software baud rate, address code must be on the dial code set the address code and baud rate can control, if it's with other control devices must be set to control interface RS485, 8 data bits, 1 stop bit, no check, Pelco D agreement, and the address code and baud rate to dial the code set and electricity the road address code and baud rate.Circuit board after receiving the correct control instruction power indicator lights flashing.

1, product overview
This is a RS485 communication six-way power relay switch output circuit boards, Pelco - D agreement can be through with this device to control the relay on-off, accused of equipment can be used to control the power on and off, communication lines, or some other line of on and off.Applicable to the brake lights, road, or dc motor control, electric door.
2, the function and characteristics
Low power input DC12V with reverse connection protection
Low RS - 485 communication anti-jamming ability strong communication distance
Low baud rate address code can be set
Low communication interface with the flow and static electricity protection
When all the 10 a relay switch output
Low relay status display and feedback
Second-ranking each relay all the way users are free to set the control mode and the instruction
Low optional remote control accessories
3, specification parameters
Project parameters note DC12V over 15 v input voltage is likely to damage the static power consumption 0.2 W
Largest 3 w power consumption all relays and switch output because 6 channels
Normally open, normally closed contact way
Status indicator relay and corresponding indicator
Contact:AC270V / 10 a power, DC125V / 12 a
RS - 485 communication way
Communication protocol PELCO - D
Baud rate: 2400 to 19200 BPS
Address code 0 ~ 63
15 kv ESD protection
Work environment sealed inside the shell
Working temperature - 10 ℃ to 50 ℃